How to set your recording levels so nothing clips

You hit record, the meter’s bumping the red, and you figure the mixer will sort it out. Here’s the catch: once a take clips, it’s clipped. Nobody can un-clip it later. Getting your levels right takes two minutes and saves the whole record.

What you need

  • Your interface and recording software
  • One instrument or vocalist
  • Someone to play the loudest part of the song

Steps

  1. Record at 24-bit. Set your session to 24-bit, 44.1 or 48 kHz. That gives you plenty of room, so you never need to run hot.
  2. Have them play the loudest part. Not the sound-check noodling. Play the chorus, the big hit, the scream.
  3. Set your gain so peaks land around -12 to -6 dBFS. That’s about halfway up the meter, not the top.
  4. Don’t chase a “big” looking meter. Quiet is fine at 24-bit. Clipping is the thing that can’t be fixed.
  5. Check the waveform after the take. Flat tops mean it clipped. Back the gain off and record it again.
  6. Use the headphone mix for volume. If the player wants more of themselves, turn up their headphones, not the input gain.

Quick tip: If one hit spikes way above everything else, back the gain off. A little extra room costs you nothing.

Get it right at the source, and everything after sounds better.